Installation instructions Rangecraft Rangehoods
Fitted with Plasma-Norm Filter
7
Installation instructions
•
RPN / RPL / RPW
1. Loosen screws A & B by turning anti-clockwise.
2. Turn screw D anti clockwise until the head of the screw is raised this will extend the outer
spring bracket to allow it to engage with the cabinetry.
3.
Insert rangehood into cut out, ensure spring bracket has engaged with cabinetry and turn
screw C clockwise until the base of the Rangehood meets the lower part of cabinetry.
Do not
over tighten screw C.
4. Tighten screw A and B by turning clockwise to lock fixing bracket.
5. To remove rangehood, turn screw A & B anti clockwise to loosen bracket then turn screw C
anti clockwise to allow the Rangehood to lower slightly. While supporting the weight of the
Rangehood turn screw D clockwise to disengage the spring bracket with the cabinetry. Gently
lower the Rangehood.
6. Ensure to follow all requirements set out in the Important Information section located on page
2.
RANGEHOOD
SPRING BRACKETS
Model: RPN 90
RPL 90
RPW 90
MOUNTING POSITION
