62
Maintenance
2583701_C_EN_1812_Nortec-GS_OM
Nortec GS
6.5.6
Cleaning the Burner Assembly
The burner(s) in the Nortec GS humidifier does not require maintenance. However, if the burner(s) is not
operating properly, clean the burner(s) and spark-igniter as described below. Refer to
.
WARNING!
Risk of severe injury to personnel, or property damage!
Prevention:
Follow proper shutdown procedure before cleaning the burner(s).
1. Shut down the humidifier as described in
. Make sure that the tank has
been emptied.
2. Remove the plumbing cabinet door panel.
3. Remove the four M5 nuts that secure the blower tube to the burner assembly.
Figure 16:
1
2
3
4
5
6
7
8
9
Cleaning the Burner Assembly
1 Bolt, M6
×
14, hex-head (qty. 9)
2 Nut, M5
3 Tube, blower
4 Gasket, blower
5 Spark-igniter
6 Matting, burner assembly
7 Gasket, burner – use a new gasket every time the burner assembly is reassembled
8 Assembly, burner
9 Lock washer M6
