Condair Nortec EL-Series, Operation And Maintenance Manual

Page: 45 / 96

45 Operator Interface Nortec EL
2582954_D_EN_1811_Nortec-EL_OM
Modbus Parameters Tab
– Modbus: allows you to enable or disable the Modbus
communications protocol. Enabling or disabling Modbus
always requires a power cycle of the unit.
Options:
On
or
Off
Factory setting: Off
The following settings appear only if Modbus is enabled.
– Modbus Address : allows you to set the Modbus ad -
dress of the humidifier on the network.
Setting range:
1-247
Factory setting: 10
– Parity : allows you to set the parity bit for the data
transfer.
Options:
None, Even or Odd
Factory setting: Even
– Baudrate : allows you to set the baudrate for the data
transfer.
Options:
110, 300, 600, 1200, 2400, 4800,
9600, 19200, 38400, 57600, 76800
or 115200
Factory setting: 9600
BACnet Parameters Tab
– BACnet: allows you to enable or disable the BACnet com -
munications protocol. Enabling or disabling BACnet always
requires a power cycle of the unit.
Options:
BACnet/IP – enables BACnet/IP over
the RJ45 (Ethernet) interface .
MSTP – enables BACnet MSTP
over the RS485 interface. Note: The
Nortec EL humidifier is a slave-only
BACnet MSTP device.
Off
– disables BACnet communica -
tions protocol.
Factory setting:
Off