Conceptronic C4CHCCTVKIT, Quick Start Manual

Page: 2 / 16

2 / 16
Part One: Basic Operation
1. Basic installation
1.1 HDD installation
Please install the hard disk before using this product for the first time.
Ensure correct connection of the power cable and data cable of the HDD. This product can support
either one or two HDDs, depending on the model purchased.
Note: the device can run normally without a HDD, but cannot record and playback.
1.2 Mouse connection
There are either one or two USB ports on the back panel and one USB on the front panel, any of which
can be used for a mouse, flash disk, WIFI, 3G module, etc.
2. Startup
Connect the power, turn on the switch at the back panel. The indicator light should turn on, indicating
the DVR is operational. After starting up the device will beep. The default output mode is multi-window
mode.
Note: Restart the power after an abnormal power off, and the DVR will automatically recover the state it
was in at the point of failure.
3. Turn off
There are two methods to turn off the DVR, via soft switch and hard switch.
Soft switch: entering [Main menu] and choosing [Logout] in the [turn off the system] option is referred
to as soft switch.
Hard switch : Pressing the power supply switch is referred to as hard switch.
Note: The setting information must be saved before replacing the battery otherwise information will be
lost.
4. Login
When the DVR boots up, user must login and the system provides the corresponding functions with the
user purview. There are two user settings; Admin and Guest. Passwords are set for these by the user.
“Admin” is the super user purview; “Guest” is to be used for preview and playback. User can modify the
passwords for Admin and Guest, but cannot modify the authorities attached to them.