EN
19
VZ1290
Fig. 1
a) Straightening long hair
Always hold the unit by the grip (8) and at a sufficient distance from the skin
and eyes; use a mirror.
- Divide your hair into approximately 4 cm-wide strands.
- Hold the unit in your hand according to Fig. 2.
- Starting from the roots, put the prepared strand between the straightener
plates for a moment (see Fig. 2).
- Clamp the straightener plates (5) and pull them slowly from the roots to the
tips of the hair (see Fig. 2).
- Repeat until your hair is straight.
b) Straightening short hair
The process is the same as for long hair, but instead of pulling the unit along the hair, only press the strands
between the straightener plates for approximately 10 seconds.
7. After the end of the treatment, let your hair cool and then comb it out.
8. After use, turn the unit off by moving the switch (2) to the „OFF“ position.
9. If you need to put the unit aside during use, always switch it off and put it on a fireproof surface.
10. When using the unit in a bathroom, make sure you switch it off immediately after use, and disconnect it from
the wall outlet, as the proximity of water and any contact of the unit with water are very dangerous, even if the
unit is switched off.
Ionizer function
Negative ions break up the water droplets, which results in faster hair drying. A
shorter drying time is better for the hair, keeps a softer structure and increases
shine. To switch the ionizer on/off, use the respective button (1), Pict. 3. The
lighting control lamp indicates that the ionizer is switched on.
6. Set the required temperature using the -/+ buttons (3), (Pict. 1). While the unit is still reaching the set temperature,
the relevant control lamp (4) is blinking. After the set temperature is reached, the relevant control lamp (4) is lit
continuously. The operating temperature is reached after approximately 1 minute.
Note:
If you are using the unit for the first time, set the lowest temperature so that you prevent damaging your
hair.
Fig. 2
Fig. 3
