Tips
1. 5 functions mentioned above are the automatic functions. When the blender is on, you can launch
the function by pressing the appropriate button.
2. You can prolong the operating time according to the type of food, the amount of food and your
taste.
3. To pause the ongoing function, press the button of the appropriate function again. The display
shows a word “PAUS” indicating that the function is paused. Then the display will be alternating
between the word “PAUS” and the remaining operating time. When the operation is paused, you
can put additional food and do other tasks. To continue with the operation, press the button of the
paused function again. The word “PAUS” disappears and the blender will continue operating for the
remaining set time.
4. You can also stop the ongoing function completely by pressing the “ON/OFF” button.
5. We strongly advise you not to set the time to 0:00. If you set the operating time to 0:00, you will be
able to use this button again only when you remove the container from the base, unplug the power
plug, plug it in again and reattach the container.
6. If there is more than 300 g of ice cream, it is better to use the muddler.
7. While any of the function is running (especially in the case of grinding hard foods), keep the
container by pressing it lightly towards the base. Slight flickering during operation is normal. When
the operation calms down, you can take your hands off the container and continue the operation
without pressing it towards the base.
8. After a cycle is completed, please, remove the container from the base. During operation, you may
notice a reverse countdown of the set operating time. When the display shows “0:00”, it means the
cycle of the function has been completed. The blender also beeps 5 times. The blender switches to
the standby mode after 30 seconds and all light indicators go out.
9. Please, clean the container according to the instructions and use a dry clean cloth to clean the base.
A cleaned blender can be stored.
OPERATING INSTRUCTIONS
5
9
SM 3
050
Standby mode
Put the j
ar
on the base of the blender and insert the plug into a wall outlet. The power indicator lights
up, but it does not flash, it means the blender has been already turned on and switched to the standby
mode.
Activated mode
If you press the “ON/OFF” button single time when the blender is in the standby mode, all the
buttons will light up, the display show 0:00 and the power indicator start to flash, it means that you
can select a function and start blending. If you press the “ON/OFF” button again, the blender will
switch to the standby mode.
Automatic operation
1. If you press any of the buttons when the blender is in the standby mode, the power indicator will start
flashing. Blender will start to operate, the button of the selected function and the “+20” button will
light up. At the same time the LED display will show the total time and remaining operating time.
2. If you press the button of the selected function single time during operation, the blender will be paused
and the LED display will show a word “PAUS”; press the button again to continue with the operation
for the remaining preset time.
3. During operation, you can also prolong the operating time by pressing the “+20” button. Press once to
prolong the time by 20 seconds.
4. For the automatic functions the time is preset and it cannot be changed.
EN
