47
RM 3240-50
EN
JUICER (only model RM 3250)
WARNING!
Prior to any cleaning or change of the extensions, make sure the speed regulator (10) is in the OFF position and the
power cord is disconnected from the socket.
1. Put the unit on a stable surface.
2. Mount the work bowl (2) to the body of the unit (1) so that the handle points
backwards. Fasten the work bowl by turning it.
3. Mount the drive shaft (3).
4. Insert the plastic whipping extension (29) in the work bowl and fit it on the
drive centre shaft (6).
5. Put the ingredients in the bowl.
6. Fit the work bowl lid (4) and turn it slightly. The lug on the edge will click
into the hole in the work bowl handle. Make sure the drive shaft axis fits the
handle in the lid.
7. Turn the work bowl lid slightly until it clicks into place. The safety catch will
be pressed.
8. Connect the feed cord to the socket.
9. Switch the motor on and set the required speed (2 is recommended).
10. When you have finished grating, set the speed regulator in the OFF position
and disconnect the power cord from the socket.
11. Open the lid and empty the work bowl.
12. Wash the attachments and let them dry properly.
• Leave the tamper (6) inserted in the lid of the bowl to provide better safety.
• Never use the plastic whipping extension to knead dough!
• Do not let the appliance run continuously for longer than 3 minutes.
1. Put the unit on a stable surface.
2. Mount the juicer drive shaft (19) to the body of the unit (1).
3. Put the juice drain cover (18) on the body of the unit (1) so that the drain
points towards you. Fasten the cover by turning it.
4. Mount the juicer filter (17) on the juice drain cover (18).
5. Mount the selected juicer cone (16) on the juice drain cover (18).
6. Prepare the fruit to be juiced .
7. Connect the feed cord to the socket.
8. Open the juice drain downwards to let the extracted juice flow into a bowl.
9. Switch the motor on and set the speed at position 1. Do not use higher
speeds.
10. Press halves of the fruits against the rotating cone. If needed, close the juice
drain so that you can replace the juice bowl .
11. When you have finished juicing, set the speed regulator in the OFF position
and disconnect the power cord from the socket.
12. Wash the attachments and let them dry properly.
(Obr. 4)
(Fig. 5)
