78
MNV3060
EN
Program
Energy consumption (kWh)
Water consumption (l)
Rinse
0.8
6
Glass
0.7
11.5
Rapid
0.5
8
Soak
0.02
3
When using 3 in 1 detergents (tablets) the washing program parameters can vary slightly. To achieve the best washing
results, use the Auto, Strong, Normal and Economy programs.
Note:
When the dishwasher is not fully loaded it is sufficient to use the next weaker program.
Information for the programs
The stated data apply under normal conditions.
Major differences may occur due to:
• various amounts of dishes
• temperature of the supplied water
• water pressure in the mains
• surrounding temperature
• electric power network voltage tolerance
• differences due to the dishwasher‘s operation (e.g. temperature, volume of water, etc.)
Water consumption values relate to the water hardness in the medium position.
Washing the Dishes - Procedure
1. Slide out, fill and slide in both racks.
2. Check or add salt or rinse aid.
3. Put the relevant amount of dishwasher detergent in the corresponding section of the container.
4. Open the water tap fully.
5. Turn on the dishwasher by pushing the main switch (1). All the symbols on the display will be illuminated for a
moment.
6. Select the required program by repeatedly pushing the PROG button. The expected time of the program will be
displayed.
7. If you have just one rack loaded, you may select whether you want only the upper, only the lower, or both spray
arms to work by repeatedly pushing the ALT button.
8. If you use 3 in 1 washing tablets, push the 3in1 button.
9. If you need to delay the start of the washing, push the delayed ON button (5) repeatedly to set the required time
of the delay (up to 24 hours).
10. Keep pushing the door gently until it clicks to close it properly.
11. By pushing the run program button (7) you will start the preset program, or the countdown of the delayed ON.
You may suspend the running program by repeatedly pushing this button.
12. After the program is complete, the dishwasher will beep and 0 will be displayed.
13. Turn the dishwasher off by pushing the main switch (1).
14. Close the water tap.
15. Hot dishes are very fragile. We recommend waiting for about 15 minutes before you take out the dishes to let
them cool down.
16. Take the dishes out of the lower rack first, then from the upper rack to prevent water dripping from the upper to
the lower dishes.
