Concept2 LFT2047bc, Manual

Page: 74 / 84

74
EN
LFT2047bc / LFT2047wh
Defrosting
1. Disconnect the electrical plug from the mains
2. Move food from the refrigerator to place where it will not be spoiled, prepare a container to catch defrosting frost
3. Wipe the thawed water on the evaporator and the inner lining with a dry cloth, then wring the cloth out and
repeat the process until the ice has completely thawed
4. To speed up the defrosting process, you can use an ice scoop (use only a plastic or wooden scoop to avoid
damaging the seal and the inner lining) or a very fine brush in combination with the use of an adequate amount of
warm water.
5. After complete defrosting and wiping the residual water inside the refrigerator with a dry cloth, you can put the
food back in the refrigerator and switch on the appliance.
Installation instructions
• The warranty does not cover damages caused by incorrect installation.
• The responsibility for installing the appliance lies with the buyer, not the manufacturer.
• The manufacturer bears no responsibility for damage caused to people, animals or property due to incorrect
installation.
• Place the appliance on a flat place in a well-ventilated are.
• Do not place the appliance under the direct sun shine.
• The appliance should be placed at least 10 cm from the wall at the back and both sides. There should be a free
space of approximately 30 cm above the appliance as it needs to ventilate freely.
•
If necessary, use the adjustable feet at the bottom of the appliance to align the appliance in a horizontally stable
position .
Connection to the mains
• Make sure the mains voltage and current protection correspond to the values on the rating plate of the appliance.
We recommend using a separate outlet with a 16 A circuit breaker.
• Only use grounded sockets.
• Do not use multiple sockets, plugs and extension cords. There is a risk of overheating.
• The plug of the power cord on the appliance must be freely accessible even after the installation.
• Changes in a connection may only be performed by a qualified professional.
•
Electrical safety of the appliance can be guaranteed only if the protective terminal of the appliance is connected to
the protective conductor of the mains.
• The manufacturer bears no responsibility for damage to persons or property as a result of missing or bad protective
connection.
• The power cord must be positioned in a way that it is not deformed or excessively bent.