Concept2 LA7383rg, Manual

Page: 57 / 64

57
LA7383rg
EN
Display
The display lights for some time, when the appliance is connected to the mains. After that the display will witch to
the operating mode. In normal operating mode, the current temperature inside the refrigerator and the freezer are
displayed. A temperature of 5 °C inside the refrigerator and of -18 °C inside the freezer are set as default.
If the door does not get open opened and any other activity is not done within 20 seconds, the control panel gets
locked and goes out. The display lights up again when any of the buttons on the control panel is pressed or the door
is opened.
TIPS FOR USE
• We do not recommend putting hot food or fluids that are still evaporating inside the refrigerator. It will increase the
humidity inside the refrigerator.
•
Food intended for refrigerating should be wrapped or covered. It is recommended to use plastic bags, kitchen foil
or food paper to wrap food. Liquids should be stored in closed containers or bottles.
• It is also not recommended to put beverages in glass bottles in the freezer, glass can easily rupture due to low
temperatures inside the freezer.
Please follow the instructions below to avoid degrading of stored food.
•
Do not open the refrigerator door for longer than necessary, as the supply of warm air significantly increases the
temperature inside the appliance.
• Clean surfaces that may be in contact with food and drainage channels regularly.
• Fresh meat and fish should be stored in a suitable place to avoid contact with other foods.
USER MANUAL
Before first use
Before first use you should wipe the outside and inside of the appliance with a damp cloth for hygiene reasons. Wash
all removable parts with warm soapy water.
After installing the refrigerator, leave the appliance standstill for at least 4–6 hours before connecting to the mains. It
is necessary to allow the cooling gases to set down. Then you can connect the refrigerator to the mains and let it run
for 2-3 hours to stabilize a normal operating temperature. Then put fresh or frozen food inside the appliance.
Note : If a power failure occurs during the first run, wait for at least 5 minutes before switching on again or connecting
to the mains.
Setting the Temperature of Refrigerator Zone
•
Press and hold the sensor button (10) for 3 seconds to unlock the control panel.
• Use the sensor button (2) to adjust the temperature inside the refrigerator by 1 °C steps.
• The temperature of the refrigerator zone can be set between 0 and 6 °C.
• Press and hold the sensor button (2) for 5 seconds to switch off the cooling chamber. When the tone sounds, the
cooling chamber is switched off. The refrigerator temperature display shows “- -“.
•
Press and hold the sensor button (2) for 5 seconds to switch on the cooling chamber. When the tone sounds, the
cooling chamber is switched on. The refrigerator temperature display shows the temperature set before switching
off (the default value is 5 °C).
Setting the Temperature of Freezer Zone
•
Press and hold the sensor button (10) for 3 seconds to unlock the control panel.
• Use the sensor button (4) to adjust the temperature inside the freezer by 1 °C steps.
• The temperature of the freezer zone can be set between -15 and -23 °C.