Concept2 LA6983bc, Manual

Page: 57 / 64

57
LA6983bc
EN
TIPS FOR USE
• We do not recommend putting hot food or fluids that are still evaporating inside the refrigerator. It will increase the
humidity inside the refrigerator.
• Food intended for refrigerating should be wrapped or covered. It is recommended to use plastic bags, kitchen foil
or food paper to wrap food. Liquids should be stored in closed containers or bottles.
•
It is also not recommended to put beverages in glass bottles in the freezer, glass can easily rupture due to low
temperatures inside the freezer.
• Each time you open the appliance door, a warm air gets inside. That creates an under pressure inside the appliance.
It may take a few moments before the pressure gets equalised and it will be possible to open the door easily.
Please follow the instructions below to avoid degrading of stored food.
• Do not open the refrigerator door for longer than necessary, as the supply of warm air significantly increases the
temperature inside the appliance.
•
Clean surfaces that may be in contact with food and drainage channels regularly.
• Fresh meat and fish should be stored in a suitable place to avoid contact with other foods.
USER MANUAL
Display
The display lights for 3 seconds, when the appliance is connected to the mains. After that, a beep sound occurs and the
display switches splayed in operation mode. In operation mode, the actual set temperature of each zone is displayed.
Default temperatures for the individual zone are pre-set at 5 °C / -18 °C.
If an error occurs, the error code will be shown on the display. If the door does not get open opened and any other
activity is not done within 30 seconds, the control panel gets locked. After another 30 seconds of inactivity, the display
goes off completely. The display lights up again when any of the buttons on the control panel is pressed or the door
is opened.
Before first use
Before first use you should wipe the outside and inside of the appliance with a damp cloth for hygiene reasons. Wash
all removable parts with warm soapy water.
After installing the refrigerator, leave the appliance standstill for at least 2 hours before connecting to the mains. It is
necessary to allow the cooling gases to set down. Then you can connect the refrigerator to the mains and let it run for
2-3 hours to stabilize a normal operating temperature. Then put fresh or frozen food inside the appliance.
Note : If a power failure occurs during the first run, wait for at least 5 minutes before switching on again or connecting
to the mains.
Setting the Temperature of Refrigerator Zone
• Press and hold the sensor button (14) for 3 seconds to unlock the control panel.
• Pressing once the sensor button for setting the refrigerator temperature (9) reduces the refrigerator temperature
by 1 °C.
•
Pressing the sensor button (9) at 2 °C will automatically increase the temperature to 8 °C and the whole process
is repeated.
• The temperature of the refrigerator zone can be set between 2 and 8 °C.
Setting the Temperature of Freezer Zone
•
Press and hold the sensor button (14) for 3 seconds to unlock the control panel.
•
Pressing once the sensor button for setting the freezer temperature (10) reduces the temperature by 1 °C.
• Pressing the sensor button (10) at -24 °C will automatically increase the temperature to -16 °C and the whole process
is repeated.
• The temperature of the freezer zone can be set between -16 and -24 °C.