Concept2 HOME CAR PET, Manual

Page: 36 / 64

DUST RETENTION BAG FILL CHECK
When the dust retention bag fi ll indicator becomes red during operation, replace the full dust retention bag
immediately.
If the dust retention bag fi ll indicator is still red after the the bag replacement, it may be due to several
causes:
• Some of the air passages (hoses, telescopic tube, suction inlet, brush adapter, or other adapters) are
obstructed;
• Motor fi lter is dirty;
• Air outlet fi lter is dirty.
Check each of these causes and remove any of them before you start
using the appliance. Should you fail to fi nd the fault, forward the ap-
pliance to the service centre nearest to you. Never use the appliance
when the dust retention bag fi ll indicator is fully red as this may dam-
age the motor beyond repair.
MAINTENANCE
You can clean the accessories and the appliance with a wet cloth.
Never immerse the appliance in water! Do not use any aggressive
substances for cleaning, such as solvents or abrasives!
DUST RETENTION BAG REPLACEMENT
1. Disconnect the appliance from the mains, pull the hose out of the
suction inlet, and open the appliance‘s cover (fi g. 3).
2. Remove the full dust retention bag and dispose of it. Make sure it
does not get ripped open when handled.
3. Insert a new bag by sliding the pasteboard lamella into the bag
holder, and insert the holder into the appliance (fi g. 4). The bag
opening must be aligned with the hole in the appliance cover.
4. Only use the appliance when a dust collection bag has been in-
serted into it! If you forget to insert the dust collection bag, or you
place it incorrectly, you will not be able to fully close the appliance
cover.
5. Close the cover by pushing it until it clicks into the right position.
FILTER REPLACEMENT
• Filters should be cleaned or replaced when they are visibly dirty,
or the appliance‘s suction power is reduced. Check the fi lters after
every use of the appliance.
• In order not to damage the appliance, do not use it with incorrectly
fi xed fi lters.
• Before replacing the fi lters, disconnect the appliance from the
electric voltage socket.
• You can buy suitable types of fi lters from your dealer, or you can
order them with the manufacturer.
fi g. 3
fi g. 4
fi g. 5
fi g. 6
EN
36 VP 8220n