background image

OPERATING 

INSTRUCTIONS 

IMPORTANT

This shaver has been engineered to give you 
a clean, close, smooth shave. It requires 2 
AAA batteries (not included). We recommend 
using longer lasting alkaline batteries in your 
shaver. If you are not going to use your 
shaver for a long period of time or if the 
batteries are dead, remove or replace the 
batteries from the unit.
Use your shaver exclusively for three to four 
weeks so that your legs and underarms 
adjust to the shaver. At first, your shave 
might not be as close as you expect. 
However, this is normal. It takes time for your 
skin and hair to adjust to the new procedure 
and for you to learn how the effectively use 
the shaver. Caution: Most blade users will 
push too hard and therefore not get a 
satisfactory shave. You must press gently so 
the hair can get into the holes of the foil 
pressing too hard makes the hair flat. Please 
be patient; use your shaver 10 to 12 times 
before you judge its performance.

FOR HOUSEHOLD  

USE ONLY

OPERATING INSTRUCTIONS

1. Remove the battery compartment cover by 
pushing in and down toward the bottom of the 
shaver.
2. Align the two AAA batteries with the positive 
and negative positions indicated inside the 
battery compartment. Being careful not to 
bend the clips, insert the negative end of each 
battery first so it will slip easily into place.
3. Return the battery cover to its original 
position by pushing it in and up until you hear 
a small click as it locks into place.
4. To use your shaver, remove the transparent 
cover and push ON/OFF switch upwards to 
the ON position.
5. After you finish using your shaver, push 
down on the ON/OFF switch to turn the 
shaver off.
6. Ensure the batteries are installed correctly 
with regard to polarity (+ and -).
7. Remove the batteries if the batteries are no 
longer functional or if the shaver is left 
unused for an extended period of time.
8. Clean the battery contacts and also those 
of the device prior to battery installation.
9. Remove used batteries promptly.
10. Always purchase the correct size and grade 
of battery most suitable for the intended use.
11. Replace all batteries of a set at the same 
time.

Summary of Contents for LWD1C









Reviews: