pole firmly (Fig. 1). It is now in place to
rotate 360˚. Hang your garment and steam
away wrinkles. Turn as you wish.
USING PANT CLIP SYSTEM
This fabric steamer is equipped with a pant
clip system for holding pants taut for faster
and more effective steaming. The bottom
clips can be adjusted by loosening the knob
(on the telescopic pole) and moving the pole
SAVE THESE
INSTRUCTIONS
FOR HOUSEHOLD USE ONLY
UNPACKING INSTRUCTIONS
Place the box on a large, sturdy flat surface.
Carefully remove the appliance from the
packing material. Keep all plastic bags away
from children.
STEAMER
ASSEMBLY
STEP 1 - Attaching
the Telescopic
Pole and Rotating
Hanger
Insert the bottom
of the larger metal
telescopic pole into
the holder on the
unit base and screw
the set screw until
tight. (Caution: Do
not over-tighten.)
Then attach pieces
as shown in Fig. 1.
STEP 2 - Attaching the Steamer Hose
Be sure the unit is off ("O"). Insert angled end
of hose into steamer housing and twist clock-
wise to securely lock hose onto housing. (Be
sure both connections at ends of hose are
correct before operating appliance.)
Extend the telescopic pole and hang the
steam nozzle from the rotating hanger. Hose
may be stiff upon removal from box.
Hose
will relax after initial use. Handle will sit
properly on pole support once hose is
relaxed. (Fig. 5)
TURNING THE STEAMER ON ("I")
The steamer has three settings:
The pause feature allows you to stop the unit
from steaming if you need to step away from
the unit for awhile, without actually turning
the steamer off ("O").
USING ROTATING HANGER
This unit comes with a rotating hanger.
To use the hanger, simply place on top of
Fig. 1
Fig. 3
PAUSE
OFF
up and down, depending upon the length of
pants (see Fig. 3). Clip pants as shown in Fig.
4 and steam.
Please note some pants may
be too long to use the bottom clips. If that
is the case, just simply use the top clips
and let your pants hang freely.
OPERATING
INSTRUCTIONS
BEFORE FILLING
THE WATER CONTAINER
Turn the water container upside down and
inspect to make sure the valve and spring
assembly are functioning. Place the container
in the reservoir and check that it is seated
securely. If the container has been stored
with water inside, it may be necessary to
remove the water and clean the container.
ON
