OPERATING INSTRUCTIONS
FILLING THE WATER RESERVOIR
(PRIOR TO PLUGGING IN THE APPLIANCE)
Remove the hose cap. Fill the reservoir with clean tap water to
the desired level or until water reaches “25 MAX” line on the
side of unit. DO NOT OVERFILL as this will cause water to boil out
of steamer and spill. Empty until water is level with “25 MAX” .
DO NOT FILL THE CONTAINER WITH HOT WATER OR ANY OTHER
LIQUID, ADDITIVE OR CHEMICAL.
OPERATING THE STEAMER
1. Over-the-door hanger accessory: hang this over the top of your
door and use to hang the T-nozzle and any garment or hanger.
(Overloading may cause deformation of door hook.)
2. Make sure the I/O switch is in the “0” position.
3. Make sure all hose connections are secure and tight
4. Hang the T-nozzle off the door hook.
5. Plug the cord into a 230/240V electrical outlet.
6. Turn the I/O switch to the “I” position.
7. The switch will light to indicate when power is on and the steamer
will begin heating.
8. Steam will be produced from the nozzle in about five to six
minutes. Be sure to keep T-nozzle on the door hook while heating
up.
NOTE : This steamer is designed to sit on the floor. Do not put on a
table or chair when in use.
