28
COMUNELLO
®Copyright 2020 - All rights reserved
• Adjust as needed using the 4 screws in the 4 corners (FIG. 6) in accordance with the instructions in FIG.8.
• Secure the gearmotor on the backplate using the dedicated nuts and washers (FIG. 7).
• Position the rack above the pinion, leaving a clearance of 1 to 2 mm between the teeth. This clearance must remain constant along the entire
length of the rack (FIG. 8).
FIG. 6
FIG. 7
FIG. 8
2 mm
• To assemble the rack modules and ensure their proper coupling, rest a section of rack under the connection point and block it with two clamps
as shown in figure 9.
• Secure / join the rack to the gate (FIG. 9A).
FIG. 9
FIG. 9A
Summary of Contents for FORT 1000
