9.
Enter the base I/O address of the controller (in hexadecimal) and press Enter.
10. Enter an unused interrupt vector number for the controller and press Enter.
Note: The device driver may suggest an IRQ that is in use. If you choose an existing IRQ,
the system may allow you to change it.
11. Enter y or n to verify the configuration.
You will then be asked if you want to configure another controller board. Repeat steps 9 -
11 for each controller (maximum 4). Type n and press Enter when all of the controllers are
configured.
The following message is displayed:
The UNIX Operating System will now be rebuilt.
This will take a few minutes. Please wait.
12. Type y to boot the kernel by default. Press Enter.
13. Type y to rebuild the kernel environment, then Enter.
14. The following message is displayed:
Setting up new kernel environment
Press any key to continue.
15. Select Quit and press Enter.
16. Select Yes and press Enter.
17. Remove the driver diskette from the floppy drive.
18. Power off your system.
After the device driver is installed, use the appropriate tables in the following sections to
configure the controller. The configuration is based on your selection during the device driver
installation. For additional address settings, see the documentation that came with your
controller.
Note: Install the controller board after you set the DIP switches. Do not change the DIP switch
settings while the board is in the computer and powered up.
