Hostess
®
550 Series
Device Driver for SCO
™
UNIX
®
Software Installation Documentation
Scope
Use this reference card to install the Hostess® device driver software and controller board
hardware. This device driver can support up to four of the following Comtrol Hostess
controller boards:
•
Hostess 550 2-port
•
Hostess 550 4-port with 100-pin or RJ45 connectors
•
Hostess 550 8-port with 100-pin or RJ45 connectors
•
Hostess 550 16-port
To use this device driver, you must have the SCO UNIX operating system installed on an ISA-
or EISA-bus machine. The installation follows these general steps:
1.
Remove existing Comtrol drivers. (Recommended.)
2.
Install the device driver.
3.
Configure and install the controller board.
4.
Configure and attach the interface box (if applicable).
5.
Enable the ports on the controller.
Note: For more information, see the hardware documentation for your controller board and
interface box.
