DT4572 X-Band Down Converter
Rev. 0
Installation
MM/DT4572.IOM
13
Power
Supply
Reference
Oscillator
Fine
Step
Module
Sum
Loop
Module
Monitor & Control Assembly
RF Converter
Prime Power Cord Input
5/10 MHz Ref. Osc. Input
J2
P1
J1
J3
J4
J5
J7
J9
Summary Fault Relay Output
Serial Comm. Interface
(RS-485 / RS-232C)- COM 1
High Speed Bus (HSB)
IF Ouput (IF)
J6
J8
RF Input (RF)
Transmit
I/O Switch
Module
(TSM)
IF Loop Input (LP IN)
IF Loop Output (LP OUT)
Not Used
Not Used
Figure 6. Converter Signal and Interconnecting Cable Diagram
(with TSM Switching Module)
2.4.5 C
ABLE
C
ONNECTIONS
F
OR
N
ON
-R
EDUNDANT
S
YSTEM
O
PERATION
In non-redundant converter configuration the converter has an Input/Output Module
(IOM-XX) for the RF input and the IF Output. A converter with a Transmit or Receive
Switch Module may be operated in a non-redundant configuration if an IOM is
unavailable. Figure 7 is an illustration of the converter cable connections with an IOM
installed. Figure 8 is an illustration of the converter cable connections with a TSM
installed.
2.4.6 C
ABLE
C
ONNECTIONS
F
OR
R
EDUNDANT
S
YSTEM
O
PERATION
In subsystems where a redundant converter configuration is used, the backup Converter
has an Input/Output Module (IOM-XX) and the online converters have Receive Switch
Modules (TSM-XX) which switch to the backup Converter when a fault is detected.
Redundant system operation is discussed in Appendix A, Redundant System Operation.
Summary of Contents for DT-4572
