StealthLock
®
, Keyless Invisible Security 5
Battery Installation - Transmitter Pad
During initial
installation, remove
the red ribbon to
activate the installed
battery
To replace the battery, insert a
small flat blade screwdriver into
the battery tray slot as shown
Press the screwdriver in and
down to release the battery tray
Replace old battery with fresh CR2032
making sure that the positive (+) side of the
battery is facing down in the battery tray
Slide the battery tray back into the transmitter
housing and snap into place
The Transmitter Pad uses a CR2032 battery
that is expected to last 2 years in normal
operation (4 open/close cycles per day).
Batteries should be replaced on an annual basis
to insure continued reliability.
The LED will begin to blink after
5,500 operations to warn that
batteries need to be replaced
StealthLock
®
, Keyless Invisible Security 6
Installation Instructions – Receiver Latch
The StealthLock
®
is designed to operate within non-metallic cabinetry. Use with other
materials may limit or prohibit operation of the lock. We recommend testing the lock if
using in a material other than wood. Batteries should be installed before installation.
The SL-100 StealthLock
®
kit is designed for
mounting in cabinets with solid panel
construction and full overlay doors. An
INSTALLATION VIDEO and tips for
mounting this kit in other cabinet types can
be found at
www.stealthlock.com
Step #1 - Position the Receiver Latch with
strike plate and installation tool attached as
shown. The front tabs on the installation tool
should contact the front edge
of the cabinet
Installation Tool Tabs
Front Edge of Cabinet
Step #2 - Screw the Receiver Latch in place using
2 of the #6 x ½” screws supplied, in the front side
of the oval holes. If attaching to material less than
¾” thick, alternate fasteners may be required.
Start with Screws in Front
Side of Oval Holes
