- 4 -
2. INSTALLATION OF THE DEVICE
Warning! The device must be installed/put into service by a competent person! Before commissi-
oning make sure that neither the thermostat nor the appliance you want to connect to is connec-
ted to the 230 V mains. Modifying the device can cause electric shock or product failure.
Caution! The voltage 230 V is displayed when the output of the appliance is switched on. Make
sure that the wires are properly connected and that that there is no risk of electric shock or short
circuit!
Connect your device as follows:
● Before installing, disconnect the immersion sleeve from the back of the pump control after
loosening the screw there. After installing the immersion sleeve, place the pump controller’s
heat sensor in the immersion sleeve and reattach the device again to the immersion sleeve
using the screw.
● Connect the 3 wires to the pump you want to control. The marking of the wires are based on
the EU standard: brown - phase, blue - zero, green-yellow - earth.
● Connect the pump controller to the 230 V mains using the pre-mounted connector