Default 1:
Off
Option 2:
Locks the doors when the ignition is on and after the brake is depressed.
Option 3:
locks the doors when the RPM’s have reached two times that of idle speed (this setting
requires that a tachometer wire is connected).
With both settings, the doors will unlock when the ignition is turned off. If using this feature on a manual
transmission vehicle, the doors will unlock upon setting the emergency / parking brake.
Turbo Timer Mode
The built-in turbo timer keeps the vehicles engine running for either 1, 2 or 4 minutes
(programmable from dealer with
Option 2-2
) after the vehicle key has been removed from the
ignition. This feature will keep oil running through the turbo system to allow for appropriate
cooling time. Tap buttons
simultaneously for 0.5 seconds to turn on or off
turbo mode. The remote will beep and the
icons
will illuminate to confirm that turbo mode is
activated. Tap the
buttons again and the remote will beep and the
icons
will
illuminate to confirm that turbo mode is off.
IMPORTANT:
To utilize this feature, the emergency / parking brake wire must be connected to the
CompuStar system. Consult your local authorized CompuStar dealer for installation.
Car Call/RPS (Remote Paging Sensor)
The car call/RPS feature uses a remote paging sensor that is designed to be mounted on the inside of
the windshield. After the RPS has been triggered, the car call icon will illuminate and the remote will ring
several times if the remote is in range to receive commands. To trigger the car call or RPS sensor, you
must knock on the windshield in front of the RPS at least two times. The switch on the RPS will adjust
paging sensitivity – the smaller the dot represents the least sensitive setting. Use a key or pen for best
results.
RPS (Remote Paging Sensor) Unlock/Disarm
(Optional with the 2WSHLCDR and 2WSHLEDR) Basic RPS and car call functions do not require
programming, however in order for the sensor to unlock/disarm the vehicle you must perform the
following procedures;
STEP 1:
Disarm/unlock the alarm (remote must be programmed first)
STEP 2:
Turn ignition key to the “on” position and the leave the driver’s door open.
STEP 3:
Knock on the windshield in front of the RPS a total of 10 times (each time you knock the LED on
the RPS will flash RED). The LED will begin to flash rapidly in BLUE with successful completion of this
step.
STEP 4:
Enter the first digit of the desired four digit pass code by knocking on the windshield in front of
the RPS the desired number of times. For example, to enter 3, knock on the sensor 3 times (each time
you knock the LED will flash RED) then wait.
STEP 5:
The LED on the RPS will confirm your first number by flashing BLUE slowly. Once the LED
begins to flash rapidly in BLUE, enter your second number by repeating step 4.
STEP 6:
Repeat steps 4 & 5 to enter all four numbers.
11
