background image

FT-MB221-DC Installation Guide

Data Controller (DC) 

Remote Start for Mercedes 

2007 - 2012 CL and S Class

www.compustar.com 
888.820.3690

Copyright 2010 Firstech, LLC. | 2

Instructions for CL Class

1. Open the cup holder in the center console and remove the two rubber stoppers by pulling them   
    straight up. A pick tool may help you get it started.
2. Remove (2) T-20 Torx screws from below the stoppers.
3. Pull the cup holder straight up and set it aside.
4. Slide the ashtray toward the back of the car so you can tilt it up slightly.
5. Remove the power connector from the lighter socket and remove the ashtray from the console and    
    set it aside.
6. Using a panel tool, pry up on the vent above the clock to remove it from the cluster bezel.
7. Remove (1) T-25 from under the vent you removed in step 6.
8. Lay a towel or protective mat over the console to give you a place to set the HVAC panel once it’s
    removed.
9. Gently pry around the edges of the HVAC bezel to loosen the clips.
10. At the very bottom of the HVAC bezel is a steel bracket that is hooked around a piece of plastic.    
      Reach under the bottom edge and push up on the plastic while pulling down on the steel bracket     
      to allow them to separate and release the lower edge of the HVAC panel.
11. Lay the panel face down on your protective mat and disconnect all the connectors. Set the HVAC    
      panel aside.
12. Remove (4) T-20 screws from the changer, remove the changer from the dash, unplug all the plugs    
      and set it aside.
13. Reaching through the changer cavity, unplug the 2 plugs from the rear of the EIS, starting with the 
      black plug which is on the bottom.
14. Follow steps 1-3 of the S Class manual to remove the driver’s under dash panel.
15. Route the harness from the changer cavity to the driver’s under dash area.
16. Route the T-Harness up from the under dash area to the changer cavity.
17. Plug the T-Harness into the rear of the EIS.
18. Insert the plugs into the control module matching the marks on the plug and the connector,  

 

      “C1” and “C2.”
19. Plug the other end of the T-Harness into the factory wiring, white plug first, then black.
20. Follow steps 9-16 on the S Class section to power up and test the remote start as well as
      reassembling the under dash panel.
21. Lay the HVAC panel face down on the protective cover on the console and reinstall all plugs into         
      their respective sockets.
22. Snap the HVAC panel back into place on the dash making sure the metal bracket at the very 
      bottom is snapped past the plastic it hooks on to.
23. Install (1) T-25 Torx screw at the top and reinstall the vent.
24. Slide the ashtray back into place and connect the lighter socket power.
25. Reinstall the cup holder and the (2) T-20 Torx screws that retain it.
26. Reinstall the rubber stoppers that cover the screws.

Summary of Contents for FT-MB221-DC









Reviews: