Resetting Menu Options
22
21
You can only program one option at a time. You will have to repeat the
procedure to program additional options. Please read through the procedure
before beginning.
1.Enter programming by pressing the button, and the button
simultaneously until the parking lights flash once.
2.Tap the button the number of times equal to the option you would like to
change. For example, if it were the 2nd option in the menu that you would
like to change, you would tap the button two times. The parking lights will
flash and the siren will chirp each time you tap the button.
3.Wait a few seconds, and the parking lights will flash the number of times
corresponding to the option number you are about to modify. If the number of
times the lights flash does not correspond with the option you want to change,
wait a few seconds and the siren will sound, signaling that you have
exited programming mode. After the siren sounds, you can retry the
process from the beginning.
4. Immediately after the parking lights stop flashing from step 3, press:
a. The button for the factory default setting. The parking lights will
flash once.
b. The button for the optional setting. The parking lights will flash twice.
4. 30 sec Passive Relock
With this option enabled, after disarming the system with the remote,
the system will relock the doors and arm the alarm after 30 seconds if a door
has not been opened. At 10 and 20 seconds after the disarm command was
given, the siren will chirp once to indicate that the alarm is about to rearm.
At 30 seconds after, the siren will chirp once, and the system will arm the
alarm. If you wish to stop this process, you must open a door within 30 seconds
of disarming the alarm.
5. Double Pulse Unlock
With this option enabled, the unlock wire will perform a double pulse every
time the unlock command is given. Some vehicles require this double pulse
to operate the locks correctly.
Programming Menu Options
If you are not sure about current programming, you can change everything to
the factory settings and start again.
1. Enter programming by pressing the button, and the button
simultaneously until the parking lights flash, and siren chirps, once.
2. Tap the button 3 times, waiting for a parking light flash and siren chirp
between each time.
3. The parking lights will flash, and the siren will chirp, three times, signaling
that all of the options have been reset, and that you have exited
programming mode.
