SYSTEM COMPONENTS
This monitor can be mounted in place of the rear-view
mirror. Make sure the view is suitable to the driver to
observe the images. Take care not to block any
necessary viewing area when mounting. Before
mounting the system, permanently hook up all
connections to ensure proper operation. This monitor
can also be clipped over and existing mirror monitor
Mounting Monitor
1.
Carefully detach the original rear view mirror in
the vehicle. Leave the original mounting slug on the
windshield.
2.
Slide the new monitor bracket over the existing
mount point on the windshield. If there is a problem
with compatibility, a new mounting slug has been
provided that will fit the monitor bracket. Glue the flat
side of the slug to the windshield with the narrow end
pointing up. Slide the monitor bracket over the new
mount point, and tighten the set screw in the mount
until snug. Do not overtighten.
3.
Connect one end of the power cable (wire) to the
proper connections. Connect the other end of the
power cable (plug) to the monitor; connect the monitor
and the camera with the system connecting cable.
Post Bracket
or Clip-on