This device is intended only for OEM integrators under the following conditions:
1) The antenna must be installed such that 20 cm is maintained between the
antenna and users. For laptop installations, the antenna must be installed to
ensure that the proper spacing is maintained in the event the users places the
device in their lap during use (i.e. positioning of antennas must be placed in the
upper portion of the LCD panel only to ensure 20 cm will be maintained if the user
places the device in their lap for use), and
2) The transmitter module may not be co-located with any other transmitter or
antenna. As long as the 2 conditions above are met, further transmitter test will not
be required. However, the OEM integrator is still responsible for testing their
end-product for any additional compliance requirements required with this module
installed (for example, digital device emissions, PC peripheral requirements, etc.).
IMPORTANT NOTE:
In the event that these conditions can not be met (for example certain laptop
configurations or co-location with another transmitter), then the FCC authorization
is no longer considered valid and the FCC ID can not be used on the final product.
In these circumstances, the OEM integrator will be responsible for re-evaluating
the end product (including the transmitter) and obtaining a separate FCC
authorization.
End Product Labeling:
This transmitter module is authorized only for use in device where the
antenna may be installed such that 20 cm may be maintained between the
antenna and users (for example access points, routers, wireless ADSL modems,
certain laptop configurations, and similar equipment). The final end product must
be labeled in a visible area with the following:
"Contains TX FCC ID: TK4-WLM54GP23".
Manual Information for End Users
The end user must not have manual instructions to remove or install the
device. The user manual for end users must include the following information in a
prominent location.
"IMPORTANT NOTE:
To comply with FCC RF exposure compliance requirements,
the antenna used for this transmitter must be installed to
provide a separation distance of at least 20 cm from all persons
and must not be co-located or operating in conjunction with
any other antenna or transmitter."
