8.
FOUR CHANNEL MATRIX MODULE
The four-channel matrix provides four outputs and four tape returns to accomodate 4-track recorders while still
allowing a normal stereo or two-track mix.
Connections to the 4-track device is made through a 10 pin LEMO connector and Lemo to XLR adaptor cable.
8.1 Channel assign Switches:
The first 9 rows of switches select which Input (1 through 9) is directed to which output (A through D). Switch up is
off, switch down is selected. The signal is taken from the channel after the fader and is still available on the Left &
Right mix bus.
For example: To direct channel 1 to Output C, Switch 1-C would be down.
To direct channel 3 to output B, Switch 3-B would be down.
8.2 Master assign Switches:
The switches L & R direct the signals from the L & R Master Faders to Output A through D.
Caution should be exercised if a L or R mixed Output is combined with the output of an individual channel.
A Mono mix can be obtained on a single channel by selecting the same output for both L & R.
8.3 Overload indicators
Overload indicators light whenever a channel is being overdriven.
8.4 Monitor Switches
The IN/OUT A to D Switches direct the Output of the mixer or the Input to the mixer to the monitoring circuit. These
switches are provided with a center Off position.
PFL light on the Master module indicates if one or more of these switches is active.
8.5 Trim pots
The four Trim pots on the circuit board will control the return level.
The module is supplied with a ribbon cable with connectors to attach to J-5 of each of the Input modules.
RETURN TO TABLE OF CONTENTS
Seite 18 von 22
SONOSAX SX/S USER MANUAL
26.08.2004
file://D:\Z_Library\Webcopy\sonosax\SXS\sxsume.html
