1. 2 zones relays can be programmed for opening the lock , up to
1000 user cards and correlative codes can be stored into ZONE 1,
10 user cards or code can be stored into ZONE 2. In addition the
ZONE 1 can be programmed for 3 modes to open the lock:
only the card access ,both the code and card access , combined
access. The ZONE2 could be programmed for door bell.
2. Default code is 1234.(memory address:1BA0,1BA1, 1BA2)
3. Input the default coed twice
mode, mode indicator will turn yellow.
(1234+1234) to enter the setting
Enter the programming mode .
1.)Press the button
and
, the mode indicator will flash
yellow, follow the button
twice, the mode indicator will turn
yellow. a long beep will be heard. It indicates that only the card
access is available.
2.)Press the button
and
, the mode indicator will flash
yellow, follow the button
and
, the mode indicator will turn
yellow .a long beep will be heard, It indicates that both the card
and code access are available.
3.)Press the button
and
, the mode indicator will flash
yellow, follow the button
and
, the mode indicator will turn
yellow and a long beep will be heard, It indicates that the card and
code access combined is available.
Press the button
to quit the setting mode .
Enter the setting mode(ZONE 2).
Press the button
and
,(mode indicator will flash
yellow ,press one number from 00 to 99,(mode indicator will
flash yellow ,it indicates there is already the data existed if turn
red.clean the data existed at this address by pressing the button
twice, the flashing green LED indicates that the user cars and
code are allowed to add), swipe the user card or input the 5-Digit
code XXXXX, (a long beep will be heard ,it indicates that adding
success) press the button
to quit, repeat the steps as above
to add others.
Operation
Enter the setting mode(ZONE 1).
Press one number from 000 to 999,(mode indicator will flash
yellow ,it indicates there is already the data existed if turned red.
clean the data existed at this address by pressing the button
twice, the flashing green LED indicates that the user cars and
code are allowed to add), swipe the user card(a long beep will be
heard , it indicates adding success) and input the 5-Digit code
XXXXX, (a long beep indicates code adding success)
Press the button
to quit, repeat the steps as above to add
others.
Enter the setting mode.
Press the button
and
, the mode indicator will flash
yellow, follow the number (from 00 to 99), the mode indicator will
turn yellow in the mean time a long beep will be heard, it indicates
a success of delay time. 00-99 mean the delay time i.e. 05 means
the unlocking time is 5s delayed.
Press the button
twice to quit the setting mode.
3
4
B. Add the user card and code
C. Add the user card and code
D. Set the unlocked time for ZONE 1
A. 3 modes by allowing to open the doorlock for selectable
UnRegister
ed
