Compatible Brands CB24BEVERAGE, Owner'S Manual

Page: 6 / 16

5
INSTALLATION INSTRUCTIONS
Before Using Your Beverage Center
Remove the exterior and interior packing.
Before connecting the Beverage Center to the power source, let it stand upright
for approximately 2 hours. This will reduce the possibility of a malfunction in the
cooling system from handling during transportation.
Clean the interior surface with lukewarm water using a soft cloth.
This appliance is especially designed for the storage of beverages; do not use it
for other purposes.
Installation of Your Beverage Center
This appliance is designed for free standing or built-in (fully recessed) installation.
If free standing, the unit should have at least 4” of clearance at both sides, at the
top and at the back to allow for adequate ventilation.
If the appliance is to be built-in, leave at least 7/25
” at both sides, 3/5” at the top
and 2” at the rear. Be sure that airflow under the appliance is not blocked. The
diagram below shows the correct dimensions for under-counter installation:
Place your Beverage Center on a floor that is strong enough to support it when it
is fully loaded. To level your Beverage Center, adjust the leveling legs at the
bottom of the unit.
Locate the Beverage Center away from direct sunlight and sources of heat (stove,
heater, radiator, etc.). Direct sunlight may affect the exterior surface and heat
23.62”
23.54 ”
23.82 ”
(min)
34”
3.5 4”
34.60 ”
(min)