e
item 07 146
3
Instructions for charging:
ź
For batteries with cell closures, remove the cell
closures and check out the status of the battery
charging. If the electrolyte level is below the
recommended level, add distilled water.
ź
For batteries without cell closures, carefully follow
the manufacturer's charging instructions.
ź
Make sure that the vehicle's ignition is switched off
(if the accumulator is connected in the vehicle).
ź
Connect the charger, always follow these steps:
ź
Insert the positive clamp of the charger (red) to the
positive (+) terminal of the accumulator.
ź
Connect the negative clamp of the charger (black)
to the negative (-) terminal of the accumulator.
ź
Plug the 230V plug into the mains.
ź
The charger begins to analyze the car battery, it
takes about 10 seconds.
ź
The charger automatically detects if a 6V or 12V
accumulator is connected.
ź
When the 12V accumulator is connected, the
MODE button allows you to select the charging
modes.
ź
Slow charging mode – charging current 0.8A.
Suitable for e.g. for 12V motorcycle
accumulators.
ź
Standard mode – charging current 4A. Suitable
especially for auto mobile accumulators.
ź
Winter mode – charging current 4A. Use this
mode at temperatures below +5°C.
ź
Poor polarity or short circuit indicator light -
disconnect the charger from the socket and
connect the battery correctly.
ź
Indicates that the battery is charging.
ź
When the accumulator is fully charged,
charging is interrupted, and charger switches to
maintenance mode where the microprocessor
controls pulse charging to keep the
accumulator in a charged state.
ź
Always disconnect the charger from the 230V
mains and after then from the accumulator after
charging.
ź
If you have opened the battery cell closures, you
must close them again.
Warning:
Heavily discharged and damaged car batteries can
not be charged by using this charger. If the 12V car
battery voltage drops below 8V, the microprocessor in
the charger will mark the battery as damaged and will
not charge it!
If the 12V car battery voltage drops below an
acceptable level, the charger can evaluate this car
battery as 6V and will not charge it properly!
The manufacturer does not take responsibility for
accidents or damages resulting from non-compliance
with this manual.
Changes in text, design, and technical specifications
could be changed without previous warning and we
reserve the right to change them.
Disposal and recycling
Do not dispose power tools and devices into the
household waste!
According to European Directive 2012/19 / EC on
Waste Electrical and Electronic Equipment (WEEE)
and in the enforcement of national law, used power
tools must be collected separately and shipped to an
appropriate recycling plant.
Technical data
Power input
230 V ~ 50Hz
Power
max 70W
Charging current
mode 6V
7,3 V=; 0,8A eff.
mode 12V
14,4V=; 0,8A eff.
mode 12V
14,4V=; 4,0A eff.
mode 12V
14,7V=; 4,0A eff.
For baterry
12V 4 - 120 Ah
Operating temp
erature
- 20 °C ~ + 50 °C
Model
BT-Z4.2
