Solar battery charger 12V
Solar battery chargers designed for permanent keeping the battery in good condition. Ideal for use in
prolonged immobilisation, eg. On vacation or in the garage.
Simply put behind the windshield and get involved in the cigarette lighter socket of 12 V, or with clips directly
to the battery.
Thanks to the power of 1.8 W will make your car battery is always ready and in good condition. They will not
lose their capacity due to self discharge or constant load conventional vehicle systems (alarm, radio, etc.).
It is suitable for all types of 12V lead-acid batteries and works even on cloudy days. Caution - can not be
used to charge other batteries (eg. Ni-Cd, Li-ion or conventional batteries (zinc-carbon, alkaline, etc.)).
Instructions for use
This instruction manual is included with the product. It contains important instructions for putting into ope-
ration and to its
Instructions. If you give the product to others, make sure that you handed them the manual as well.
Keep this manual so you can read them again anytime!
Intended use
The solar car battery maintenance charger is used to maintain the capacity of 12 V lead-acid batteries in
cars, motorcycles, boats, tractors and the like. The solar panel converts sunlight into electricity, and provi-
des an independent source to maintain battery capacity. The charging current is sufficient to compensate for
the spontaneous self-discharge lead-acid batteries.
You can not charge Ni-Cd / Lithium batteries or conventional batteries (zinc-carbon, alkaline, etc.).
When connecting pay attention to correct polarity!
This charger can not be used in vehicles when they are in operation.
Equipment is required before starting the engine, always disconnect.
Installation and connection
When you connect the product always pay attention to the correct polarity and the charging instructions
prescribed by the battery manufacturer.
Fixing
Solar panel provides sufficient amount of charging current in the event that it is oriented towards the sun. For
fixing the suction cup included with the product. Ensure that all the suction cups in the holes for fixing to the
article and move the suction cups to the side. Now the suction cup secured to the article. Moisten slightly
rubber surface suction cup and press the panel to the specified location, which should be clean and smooth
(side or windshields, etc.).
Connection
For internet are 2 different adapters. Connectors for connection are protected against incorrect polarity and
can therefore only connect to the correct terminal. Shoe contact or red clamp always belongs to the positive
pole. External contacts or black terminal belongs to the negative.
Adapter designed to plug the cigarette lighter socket
Warning - in some vehicles the connector is active only in the case when the vehicle ignition is turned on. In
this case, select the connection via terminals directly to the battery.
Adapter with terminals for connecting directly to the battery
(Red terminal = positive, black terminal = negative pole).
E
6
item 07 168