Monitoring your 11Mbps Wireless LAN Network
5-25
System Intervals
To display the system interval parameters to monitor the Access Point, you must
first connect to the target Access Point as described in “Connecting to Access
Points” on pag e5-18.
Select the
System
tab and click the
Options
button to display the window pictured
in Figure 5-10.
Figure 5-10 Intervals window
In the Intervals window two different time interval parameters can be set to
change to monitor interval settings:
■
Analysis polling interval (used for remote link test)
■
SNMP polling interval (used for SNMP statistics)
Adjusting Analysis Polling Interval
Subject to the type of connection, you can adjust the refresh rate of the remote
link test results, also identified as the analysis polling interval.
While the remote link test will proceed to continuously collect measurement
results, the selected Access Point (initiator station) will transfer the results to the
LAN administrator station at regular intervals, which can vary from 1 to 15
seconds.
■
Use a short time interval (e.g.1 second) for on-line monitoring, e.g., when
troubleshooting or when you have full bandwidth access via the local
network.
Summary of Contents for WL110
