Compaq WL110, User Manual

Page: 109 / 144

Advanced Network Configurations 8-9
❏
Access Point
“IP address”
(unique for each Access Point, in case of a
BOOTP or DHCP server, this IP address is entered automatically).
❏
Access Point
“Subnet Mask”
(the same for all Access Points, in case of a
BOOTP or DHCP server, this IP address is entered automatically).
❏
(optional)
Default router
(usually the same for all Access Points).
❏
(optional)
Default TTL
(Time To Live) (usually the same for all Access
Points).
All parameters are explained in the next paragraphs.
3. When finished, proceed with configuring other parameters or click
OK
to
save the configuration and return to the main A PManager window.
Figure 8-5 Setup Access Point IP Parameters
IP address
Each Access Point needs an unique IP address. Use either:
■
DHCP, to obtain an IP address automatically, or
■
manually enter an IP address
Note: All Access Points must have a unique IP address value to allow you to
address each Access Point specifically. Duplicate IP address values may
cause unexpected behavior of the network and/or negative impact on
network performance.
Manually assign an IP address