Installation
ELSA GLoria Synergy Graphics Controller Installation Guide 2–5
_________________________ Caution ___________________________
Static electricity can damage sensitive electronic components. When handling
your graphics option, use an antistatic wriststrap that is connected to a grounded
surface on your computer system.
____________________________________________________________
1.
Perform a normal power down of your computer system and disconnect the monitor
cable.
2.
Remove the cover from your computer (refer to your system documentation).
3.
Put on an antistatic wriststrap.
_________________________ Caution ___________________________
An antistatic wriststrap must be worn when handling any module to prevent
damage to the module.
____________________________________________________________
4.
If your computer has an existing graphics module, remove the screw that secures it
and then remove the module.
5.
If your system had a previously installed graphics option, you can use that slot if it is a
PCI slot, or you can select any empty PCI expansion slot. Remove the slot cover if
you are using a new slot. Refer to your system owner’s guide for information about
graphics option slots.
6.
Grasp the top edge of the graphics option and carefully insert it into the slot, then
firmly seat it.
7.
Secure the module retaining bracket.
8.
Replace the computer cover.
9.
Ensure that the monitor cable is connected to the video output connector located on
the back of the graphics option.
10.
Perform a normal power up of your computer system.
