steps:
1.
Remove the outer access casing (see Section 7.3).
2.
Remove the Memory Expansion Board access plate (see Section 7.12).
3.
The memory board is secured to the system board by six PCB standoffs.
To
remove the memory board from the system board, press the top of each PCB
stand off together, one at a time.
At the same time, gently lift that
portion of the memory board from the stand off.
Repeat this procedure
until all PCB standoffs have been disconnected from the system memory
board.
4.
Lift the disconnected memory board from the system board (Figure 7-46).
To replace the memory board, reverse steps 1 through 4.
Chapter 7.21 Memory Option
COMPAQ PORTABLE II Personal Computer memory chips can be installed on the
system board, the 512/2048 Kbyte Memory Expansion Board, or the 512/1536 Kbyte
System Memory Board.
To remove a memory chip, complete the following steps:
1.
Remove the board that contains the memory chip to be replaced.
For board
removal procedures, refer to one of the following sections.
o
For the 512/2048 Kbyte Memory Expansion Board removal and replacement
procedure refer to Section 7.16.
