1-6
English
Writer: M. Silvetti Saved by: Marianne Silvetti Saved date: 03/03/98 2:55 PM
Pages: 31 Words: 6042 Template: c:\msoffice\templates\normal.dot
File Name Bk1a_en.doc Part Number 305706-004
Signal Warning Function
If something is wrong with the input signal, one of the
following messages will display for 30 seconds when the
monitor is turned on and off, or when the computer select
switch is operated (refer to page 1-9 for an explanation of the
computer select switch):
■
Please check the signal
(indicates the cable is not
connected)
Input: 1
(shows computer select switch setting)
FH:84.4kHz
(indicates the horizontal sync signal)
FV: - Hz
(indicates no vertical sync signal)
■
Out of Scan Range
(indicates the input signal is not
supported by the monitor's specifications)
Using BNC Connectors
A signal cable with BNC connectors may be used in place of or
in addition to the 15-pin signal cable. To connect two computers
to the monitor, a BNC connector may be used together with the
15-pin signal cable. If you have separately purchased a signal
cable with BNC connectors, use the following instructions to
connect the signal cable to the monitor.
✎
AssetControl is not supported by the monitor when BNC
connectors are used.
1. Connect the five BNC connectors to the monitor. Push in
and twist the connectors clockwise until they are locked
into place. The color of the wires may vary, so refer to the
manufacturer's instructions included with the BNC
connectors. Usually, the connectors are color coded from
left to right in the following order: