Setting Up, Initializing, and Booting Logical Partitions 4-5
Example 4–1 Check Configuration from Primary Console (Continued)
C8 PCI connected to kftha1 pci3
0+ SIO 4828086 0015 sio2
3+ VGA D1011 0022 vga1
6+ QLogic ISP1040B 10201077 0005 isp6
7+ QLogic ISP1040B 10201077 0005 isp7
8+ DECchip 21041-AA 141011 0021 tulip6
9+ DECchip 21140-AA 91011 0022 tulip7
A+ KZPSA 81011 0000 kzpsa1
B+ Mylex DAC960 11069 0002 dac3
Controllers on SIO sio2
➌
0+ DECchip 21040-AA 21011 0024 tulip5
1+ FLOPPY 2 0000 floppy2
2+ KBD 3 0000 kbd2
3+ MOUSE 4 0000 mouse2
6+ TOY 7 0000 toy2
EISA connected to pci3 through sio2 eisa2
Use the show config command to ensure that the correct CPU modules are
present and that there are sufficient DWLPB PCI card cages with KFE72-DA
adapters for the desired number of partitions.
➊
After power-up completes, issue the show config command from the
console prompt.
➋
The processors are KN7CG processors.
➌
Ensure that there are enough PCI card cages with KFE72-EA and KFE72-
DA adapters attached. Note that the listing for the C1 hose attached to the
KFTIA has a VGA monitor card, indicating that this is a KFE72-EA. The
SIO listings for the DWLPBs connected to slots 7 and 6 show modules
consistent with KFE72-DAs.
