4
Installing the Shipping Bracket
In the following installation procedures, directions are referred to while viewing the rackmount ProLiant 1850 from
the rear of the cabinet. The shipping bracket is used to secure the ProLiant 1850 in the cabinet during shipment or
when moving the cabinet to a new location. To install the shipping bracket, refer to Figure 1 and the following
procedures:
1.
Removing and replacing one screw at a time, remove the two screws securing the cable management arm
mounting bracket to the chassis and replace with two 6-32 truss-head screws
.
2.
Removing and replacing one screw at a time, remove the two M6 screws (2) securing the cable management
arm to the mounting bracket and install two flat washers
and two split washers , then reinstall the two M6
screws (2).
3.
To install the shipping bracket
, loosen the two M6 screws (2) securing the cable management arm to the
mounting bracket and place the large part of the two keyholes on the shipping bracket over the screw heads.
4.
Slide the shipping bracket
down, until the top hole on the left side of the shipping bracket is aligned with the
8th hole of the installation area on the left rear cabinet rail. Tighten the two M6 screws (2) securing the shipping
bracket and cable management arm to the mounting bracket.
5.
Secure the shipping bracket
to the left rear rail with two flat washers , two 10-32 truss-head screws , and
two 10-32 Kep nuts
.
