Removal and Replacement Procedures
Drive Tray
To remove a drive tray from a removable media bay:
WARNING: To reduce the risk of personal injury and to prevent damage to the
equipment, before removing the access panel, make sure that the server is powered
down, all cables are disconnected from the back of the server, and the power cord is
disconnected from the grounded (earthed) AC outlet.
NOTE: The drive trays in the removable media bays can be used to mount internal 3.5-inch hard
drives. The rails mounted inside the drive trays can be removed and used to mount other devices in the
removable media bays.
1. Complete the preparation procedures. Refer to “Preparation Procedures” earlier in this
chapter.
2. Remove the front bezel. Refer to “Front Bezel” earlier in this chapter.
3. Remove the access panel. Refer to “Access Panel” earlier in this chapter.
4. Using a Torx screwdriver, remove the screws on each side of the drive tray (1), and then
gently slide the drive tray out of the front of the chassis (2).
2
1
1
Figure 2-11: Removing a drive tray
To replace a drive tray, reverse steps 2 through 4.
2-16
Compaq ProLiant ML330 Generation 2 Server Maintenance and Service Guide
COMPAQ CONFIDENTIAL Codename: Mimic/Reaper Part Number: 234832-003 Last Saved On: 11/25/02 10:18 AM
Summary of Contents for 234664-002 - ProLiant - ML330T02
Page 6: ......
