INS_NWKED_QS_REV– 05/20/13 PAGE 4
TECH SUPPORT: 1.888.678.9427
QUICK START USER GUIDE
NWKED
FIGURE 4 – TYPICAL APPLICATION
INSTALLATION REQUIREMENTS
CONFIGURING NETWAVE
Shielded outdoor CAT 5 or better should be used for all out of plant Ethernet connection and should be properly grounded
through the PoE AC ground. Industrial grade shielded Ethernet cable is recommended to help prevent ESD damage commonly
experienced with outdoor installations. Visit www.comnet.net/comnet-products/cables
1. Connect an Ethernet cable from the port labelled as Ethernet on the Encoder or Decoder to either a laptop or a PC LAN port.
2. Connect the terminal block the provided power supply and connect to the Encoder/Decoder. Connect the power supply to a
power outlet. You should notice the red PWD LED illuminate.
3. Set the IP address of the laptop being used to configure Netwave to static and the subnet to 192.168.10.x/24 subnet.
4. Point the browser to the Encoder/Decoder IP address.
The default addresses are:
Decoder: 192.168.10.200
Encoder: 192.168.10.201
NOTE: Internet Explorer 11 in Compatibility mode is highly recommended.
5. A login prompt will pop up. Enter:
ID:
admin
Password:
123456
6. To configure the Decoder login then Select Connection Settings and set the desired settings.
• Select Apply Settings
• Select Save
• Select Reboot to store settings.
7. To configure the Encoder login then Select the Setup Tab and make the necessary changes.
• Select Apply Settings
• Select Save
• Select Reboot to store settings.
DEFAULT CONFIGURATIONS
IP Address of Decoder Web Server
192.168.10.200
IP Address of Encoder Web Server
192.168.10.201
LAN Mode for Web Server
Static Addressing
Web Server User ID
admin
Web Server Password
123456
Video Stream
MPEG4
Connection Type
TCP
Enable Audio In
Off
Enable Control Data
On
Stream Port
6002
Control Port
6001
NOTE: A Reset to defaults (performed on the ADMIN page) will erase all user configurations.
Monitor
Decoder
NW1
Access Point
(not included)
WIRELESS
COAX
CAT5
ETHERNET
VIDEO
LEGEND
10/100
Ethernet
10/100
Ethernet
NW1
Client
(not included)
Encoder
Camera
Video
