Comnet FVT80D4SFP Installation And Operation Manual Download Page 4

Page: 4 / 6

INS_FVT/FVR80D4SFP_REV–

05/07/10

PAGE 4

FIGURE 6 – SWITCH POSITIONS – FRONT PANEL

TECH SUPPORT: 1.888.678.9427

INSTALLATION AND OPERATION MANUAL

FVT/FVR80D4SFP

The mode for each data channel is configured using a set of three switches on the front panel of the unit.

FIGURE 7 – SWITCH POSITIONS – RJ45

RS232

1 NC
2 Out (-)
3 Ground
4 NC
5 NC
6 IN (-)
7 NC
8 NC

RS485 (2W)
& SENSORNET

1 NC
2 NC
3 IN (+)
4 NC
5 NC
6 IN (-)
7 NC
8 NC

RS422, RS485
(4W), Manchester
& Bi-Phase

1 OUT (+)
2 OUT (-)
3 IN (+)
4 NC
5 NC
6 IN (-)
7 NC
8 NC

NC = No Connection

Summary of Contents for FVT80D4SFP

Page 2: ...888 678 9427 NOTE Remove Electrical Connector for Rack Mount Units FIGURE 2 FVT80D4SFP TRANSMITTER FIGURE 1 FVT FVR80D4SFP TRANSMITTER AND RECEIVER FIGURE 3 FVR80D4SFP RECEIVER REAR PANEL REAR PANEL FRONT PANEL FRONT PANEL OPTICAL FIBER DETERMINED BY SELECTION OF SFP MODULE BLACK BLACK WITH WHITE STRIPE ...

Page 3: ...REEN Communication link has been established over optical fiber An active video signal is present on the BNC connector An active video signal is present on the BNC connector Unit powered up RED Communication link has not been established No Video Signal OFF Not powered up correctly No Video Signal Unit powered down FIGURE 5 RJ45 BREAK OUT ASSEMBLY 5 pc Factory Supplied ...

Page 4: ...80D4SFP The mode for each data channel is configured using a set of three switches on the front panel of the unit FIGURE 7 SWITCH POSITIONS RJ45 RS232 1 NC 2 Out 3 Ground 4 NC 5 NC 6 IN 7 NC 8 NC RS485 2W SENSORNET 1 NC 2 NC 3 IN 4 NC 5 NC 6 IN 7 NC 8 NC RS422 RS485 4W Manchester Bi Phase 1 OUT 2 OUT 3 IN 4 NC 5 NC 6 IN 7 NC 8 NC NC No Connection ...