INS_FVT1301-P_REV–
02/05/10
PAGE 3
FIGURE 4 – MOUNTING INSTRUCTIONS
See your Pelco Spectra Dome III/IV installation manual for details of dome installation.
INSTALLATION AND OPERATION MANUAL
FVT1031(M)(S)-P
TECH SUPPORT: 1.888.678.9427
Remove lower dome and dome drive from Spectra III/IV
dome according to the dome’s instruction manual to reveal
the back box (A).
Open the hinged door of Spectra III/IV back box to reveal
the circuit board (B).
Carefully move the power wiring, if necessary, to allow room
for mounting the FVT1031-P transmitter to the circuit board.
Remove the plug from the 16-pin connector on the circuit
board (C).
Align the 16-pin connector on the dome circuit board with
its counterpart on the top of the FVT1031-P and plug the
header into the connector.
Using the supplied Phillips pan head screw with lock
washer, secure the transmitter into the mounting standoff
on the dome circuit board (D).
Connect the fi ber optic connector on the transmitter to the
dome’s fi ber optic adapter (E).
Close the back box and replace dome drive and lower
dome according to the dome’s instruction manual.
A
A
B
B
C
C
D
D
E
E
D
D
