Comnet CNFE5SMS Installation And Operation Manual Download Page 2

INS_CNFE5SMS_REVA   07/08/11   PAGE 2

Tech SupporT: 1.888.678.9427

INSTALLATION AND OPERATION MANUAL 

CNFE5SMS

RJ-45

RJ-45

RJ-45

RJ-45

RJ-45

BLACK
BLACK WITH WHITE STRIPE

Power Supply:
Surface Mount: 9–24VDC@1A 
Rack Mount: From Rack

NOTE:  Remove  Electrical 

Connector for Rack 
Mount Units

FIGURE 2 – CNFE5SMS

FIGURE 1 – CNFE5SMS

REAR PANEL

FRONT PANEL

FIGURE 3 – UPLINK SWITCH SETTINGS

EFFECT

UPLINK

Uplink Enabled

oN

Uplink Disabled

oFF

Summary of Contents for CNFE5SMS

Page 1: ...t network device There is no programming required to use this switch The ComNet CNFE5SMS comes pre programmed preventing network video flooding with DIP switch selection of port five as uplink or as an unmanaged switch It is Plug and Play LED indicators confirm the operating status of this device See Figure 4 on Page 3 for an explanation of the indicators The ComNet CNFE5SMS may be either wall mou...

Page 2: ...5 RJ 45 RJ 45 RJ 45 RJ 45 BLACK BLACK WITH WHITE STRIPE Power Supply Surface Mount 9 24VDC 1A Rack Mount From Rack NOTE Remove Electrical Connector for Rack Mount Units FIGURE 2 CNFE5SMS FIGURE 1 CNFE5SMS REAR PANEL FRONT PANEL FIGURE 3 UPLINK SWITCH SETTINGS EFFECT UPLINK Uplink Enabled ON Uplink Disabled OFF ...

Page 3: ...Applied BLINKING Data Activity Data Activity OFF No Data Link No Data Link Power Not Applied FIGURE 5 APPLICATION DIAGRAM WITH MULTICAST TRAFFIC IGMP Enabled on CNGE2FE24MODMS Uplink enabled on the units Camera Connections on Ports 2 4 Camera Connections on Ports 1 3 Camera Connections on Ports 1 4 CNGE2FE24MODMS CNFE4SMS CNFE4 1SMS CNFE5SMS P5 P1 P5 P4 Copper Fiber Optic LEGEND ...

Page 4: ...d cage rack 1 Make sure that the card is oriented right side up and slide it into the card guides in the rack until the edge connector at the back of the card seats in the corresponding slot in the rack s connector panel Seating may require thumb pressure on the top and bottom of the card s front panel CAUTION Take care not to press on any of the LEDs 2 Tighten the two thumb screws on the card unt...

Reviews: