INS_CL(T,R)VE(1,2)COAX[POE][M]_REV- 04/25/13 PAGE 5
TECH SUPPORT: 1.888.678.9427
INSTALLATION AND OPERATION MANUAL
CL(T,R)VE(1,2)COAX[POE][/M]
Installation Considerations
This Ethernet unit is supplied as a Standalone/Rack module. Units should be installed in dry locations protected from extremes of
temperature and humidity.
C1-US, C1-EU, C1-AU or C1-CH Card Cage Racks
CAUTION: Although the units are hot-swappable and may be installed without turning power off to the rack, ComNet recommends
that the power supply be turned off and that the rack power supply is disconnected from any power source. Note: Remove
electrical connector before installing in card cage rack.
1. Make sure that the card is oriented right side up, and slide it into the card guides in the rack until the edge connector at the
back of the card seats in the corresponding slot in the rack’s connector panel. Seating may require thumb pressure on the top
and bottom of the card’s front panel.
CAUTION: Take care not to press on any of the LEDs.
2. Tighten the two thumb screws on the card until the front panel of the card is seated against the front of the rack.
WARNING: Unit is to be used with a Listed Class 2 power supply.
IMPORTANT SAFEGUARDS:
A) Elevated Operating Ambient - If installed in a closed or multi-unit rack assembly, the operating ambient temperature of the rack
environment may be greater than room ambient. Therefore, consideration should be given to installing the equipment in an
environment compatible with the maximum ambient temperature (T
ma
) specified by the manufacturer.
B) Reduced Air Flow - Installation of the equipment in a rack should be such that the amount of air flow required for safe operation
of the equipment is not compromised.
FIGURE 6 – INDICATING LEDS
ETHERNET LINK
(Yellow/Off)
ETHERNET ACTIVITY
(Solid/Flashing Green)
GREEN
YELLOW
RED
OFF
COAX LINK
Coax interface linked
N/A
Coax Interface Not Linked
Unit Powered Down
COAX ACTIVITY
Activity detected (flashing or
solid)
N/A
N/A
No Activity
POE
(CLTVE1COAXPOEM/M)
PoE power is being supplied. N/A
N/A
PoE is not supplied.
VIDEO DETECT
Video signal detected on the
Video BNC
N/A
No Video signal detected on
the Video BNC
Unit Is Powered Down.
ETHERNET LINK
N/A
Interface Linked
N/A
Interface Not Linked
ETHERNET ACTIVITY
Activity Detected
N/A
N/A
No Activity Detected
