Community WET II - Operation and Installation Manual - Page 21
INSTALLATION CONSIDERATIONS
Installing WET II loudspeakers is simple and straightforward. In most cases they will simply be affixed to a
wall or ceiling surface by means of the stainless steel yoke-style mounting bracket that accompanies the
four smaller models, and is available as an optional accessory to the larger models. Always pay close
attention to the type of fasteners used, the nature of the mounting surface(s), and the suitability of the
mounting method.
CAUTION!
If there is any doubt as to the structural integrity of the mounting surface(s) and/or the nature
and use of the fasteners or other mounting materials, means, or method(s), consult a licensed
professional engineer who can provide accurate information that will assure a safe and reliable
installation. The potential for injury and/or death resulting from improper installation practices and/or
inadequate materials is very high. Please read the section on Safe Rigging Practices for additional
information, found elsewhere in this manual.
C-TIP:
When installing WET II loudspeakers, particularly the larger models, it is helpful to wear a pair of
heavy-duty industrial grade rubber gloves. The glass surface material and the unique curved shape of the
enclosures can otherwise be difficult to handle.
Installing with Yokes
When attaching a yoke bracket to a WET II loudspeaker, always make sure to use the rubber washers
(supplied). They are intended to be placed between the yoke and the loudspeaker enclosure. They provide a
seal to inhibit the penetration of water into the enclosure, as well as increase the friction between the
enclosure and the yoke assembly. The bolts should be fitted with a lock washer and a flat washer
(supplied), and tightened to a torque of approximately 8 to 12 foot lbs. Be cautious, as overtightening can
cause deformation or damage to the fiberglass enclosure. Use a torque wrench!
IMPORTANT!
Make sure that all rigging and mounting fittings have bolts, lock washers, flat washers and
rubber washers installed before completing the installation. No rigging or mounting fitting should be left
open to the elements.
