Community VLF Series – Operation Manual - Page 15
CONNECTING THE AMPLIFIER TO THE
LOUDSPEAKER: VLF212P
Figure 13: VLF212P Input Panel
PIN Designations
In the
Parallel Output
Mode
the pin designation is as follows:
•
NL4 Pin 1+
and the
tip
of the
¼” jack
connect to the positive (red) output of the amplifier.
•
NL4 Pin 1-
and the
sleeve
of the
¼” jack
connect to the negative (black) output of the amplifier.
Internally, each of these pins are connected to the NL4 output connector, to the ¼” output jack, and to the
drivers in the subwoofer.
In the
Hi-Pass
Mode
the pin designation is as follows:
•
NL4 Pin 1+
and the
tip
of the
¼” jack
connect to the positive (red) output of the amplifier.
•
NL4 Pin 1-
and the
sleeve
of the
¼” jack
connect to the negative (black) output of the amplifier.
Either the NL4 or the ¼" jack on the right side of the input panel may be used as hi-pass outputs to drive
one or more full-range loudspeakers. These hi-pass outputs exhibit the response that is discussed in the
section of this manual entitled “
SELECTABLE HIGH-PASS OUTPUTS: VLF212P.”
