VERIS 2 – Operation Manual - Page 28
When equalizing a VERIS 2 loudspeaker system the following points should be kept in mind to
achieve the best results and to avoid damaging the drivers.
1. Use only small amounts of equalization. In particular, do not boost frequencies by more
than about 3 dB. Cutting frequencies by more than 3 dB of attenuation is acceptable, but bear
in mind that extreme frequency cuts will usually result in less than optimum performance,
unless carefully derived by use of a precision measurement system in a room that has
excessive resonance.
Rule of Thumb:
less is usually more
.
2. Do not attempt to boost any frequencies below 100 Hz with a graphic equalizer. Note that
with the recommended high-pass filter, moderate amounts of boost from a simple bass control
are acceptable.
FOR MORE INFORMATION AND APPLICATION
ASSISTANCE
For more information on installing and operating your VERIS loudspeaker, please refer to
Community’s web site at
www.communitypro.com
. For application support, service or
warranty information, refer to Community’s web site or contact Community at 610-876-3400
or toll-free at 800-523-4934.
