I SERIES
BalancePoint™ Flyware
Page 7
TECHNICAL DRAWINGS
(continued)
Drawings not to scale
TYP BOTH LEGS
4.00" [101.6]
6.57" [167.0]
CL
6.04" [153.4]
14.61" [371.2]
14.92" [379.1]
.59" [14.9]
.16" [4.0]
.75" [19.0]
.41" [10.5] X 1.60" [40.5] SLOT
(TYP 4 PLACES)
CL
1.50" [38.1]
DIMENSIONS SYMMETRICAL ABOUT CL
5.71" [145.2]
6.31" [160.1]
1.31" [33.4]
2.26" [57.5]
Ø.67" [Ø17.0]
Ø.43" [Ø11.0]
(TYP 6 PLACES)
IUB112SWRG
- U-BRACKET FOR WEATHER-RESISTANT IS6/8-112 SUBWOOFERS
HELPFUL INSTALLATION TIPS
• Assemble the horizontal arrays on the ground (or lifting surface) and then lift the entire assembly into
place. Large vertical arrays should be assembled top down - lifting each component and attaching it in
order. Smaller vertical arrays can be assembled on the ground and then flown.
• Assemble any arrays with the differing models (horn/coverage patterns) in the correct configuration.
• If the cabinets are horizontal, keep the input panels all on the same side for wiring ease, whenever
possible.
• To determine the approximate splay or array angles prior to installation, use simulation software such
as EASE®. Document those values, and preset the angles on the hinges and splay brackets as they are
attached to the cabinets.
• Fully tighten the connections as each assembly is finished without deforming the cabinet surface.
• Contact our Technical Assistance Group (TAG) for additional guidance by phone: (610) 876-3400 or email:
