COMMUNICATIONS-APPLIED TECHNOLOGY ICRI-E, Setup And Operating Procedures

Page: 12 / 30

- 12 -
Use an alternate DC source to power the ICRI.
When powering the ICRI with an alternate DC source or through vehicle power source , c onnect the
in-line jack to the in-line plug. Note that the pins are polarized and the connection is made so that
the jack’s locking ―blades‖ slide between the ―blades‖ on the plug and the body of the plug.
Connect the other end to the vehicle cigarette lighter. If using the NATO slang connector into the
vehicle power source.
Connect the adapter’s plug to the jack labeled
DC INPUT . Tighten locking screw, it is important
that the connector be firmly seated against the radio so that good electrical contact is made.
Note: Align the plug’s “key” with the jack’s “keyway” before attempting to insert the plug.
To release, loosen the locking screw and gently remove the connector.
Note: DO NOT remove the power cable by pulling from the cable.
FIGURE 6: NATO SLANG POWER ADAPTOR