z
Page 2
•
Adjust the relative input power level of the different carriers so that there is no
individual channel with a power greater than 200 Watts to insure the output
power level is in compliance with the values indicated in the table on page 2.
•
Install the Alarm Connector to the Alarm Output connector of the Multi Carrier
Power Booster.
Setting the RF Output Power on the MCPB-850-200 Booster Amplifier
The RF output power is not adjustable on the MCPB Amplifier. The user must adjust
the RF input power to the Booster Amplifier such that the RF output power level of
any of the individual carriers does not exceed the levels shown below in order for the
RF output spectral emissions to be compliant with the FCC spurious emissions limit
of -13 dBm outside of the assigned frequency block.
These levels must not be
exceeded.
Channel Center
Frequency (MHz)
Maximum RF
0utput (Watt)*
851-894 200
* Note: The Maximum RF Output Power is after any passive losses after the Booster Amplifier such as
filters and cables.
This equipment complies with Part 22 of the FCC rules. Any changes or
modifications not expressly approved by the manufacturer could void the user's
authority to operate the equipment.
In order to comply with FCC rules for RF exposure, it must be observed that the
antenna connected to this equipment be fixed on an outdoor structure and that it
must have a minimum separation distance of 10 meters between it and any
person."
